-40%
Stainless Steel T316: DIY Stud & Stud Cable Railing Kit for 1/8
Stainless Steel T316: DIY Stud & Stud Cable Railing Kit for 1/8
Stainless Steel T316: DIY Stud & Stud Cable Railing Kit for 1/8
Stainless Steel T316: DIY Stud & Stud Cable Railing Kit for 1/8

Stainless Steel T316: DIY Stud & Stud Cable Railing Kit for 1/8" Cable Swageless

$ 10.03

Availability: 500 in stock
  • All returns accepted: Returns Accepted
  • Return shipping will be paid by: Buyer
  • Refund will be given as: Money Back
  • MPN: S6QKH-LSST-O-18
  • Brand: Safeland
  • Restocking Fee: 10%
  • Item must be returned within: 30 Days
  • Condition: New

    Description

    Easy DIY Swageless Cable Railing Assembly Stud Kit-  1/8" Cable
    ALL Material Is Stainless Steel Type 316
    No Crimping Required, Only Pull & Tight
    en- Easy DIY
    Both Ends Are Hidden Within The End Posts,
    Providing A Clean Clear View Look.
    Good for 1/8" 1x19 Cable
    Free Thread Lock Glue With The Purchase of 10.
    Please choose length of cable from 6ft - 60ft.
    Sizes are based on the length of cable only. (i.e. 6ft = 6ft of SS 316 1x19 Cable, not including fittings)
    This cable railing kit works great for metal post or wood post. The threaded stud is already swaged onto the cable, you will just need to select the proper length of cable and push the cable through all posts to tension it with our swageless fitting. Our swagelss fitting will lock cable. The next step is to tighten the cable from the threaded stud side, that is where the thread locker is recommended to prevent our nut washer from loosening. Once the cable is tight, cut the extra cable and extra length of thread on the stud to make it flush, then apply our snap on cap to finish your job.
    We recommend
    1.
    Adding thread locker to the nut washer, either blue or red to prevent the nut washer from loosening.
    2.
    Use an angle grinder to cut the extra cable and extra thread after the cable is tightened. It should be flush for the caps.
    3.
    Then put the caps onto the nut washer and fitting.
    D
    Do
    NOT
    add the swageless quick hold fitting onto the cable before installing on the post.
    We pre-crimp one side of the cable to the swage stud. Please follow the steps below for installing.
    1. Install the stud through the first post. Add nut and washer (Do not fully tighten)
    2. Install the cable through all the post and add the quick hold swageless piece at the back end of your end post and pull the cable to fully tighten.
    3. Now you can fully tighten the nut and washer on the other end. (We recommend you use our thread locker glue)
    4. Cut the extra cable and extra thread of the stud if necessary and apply the end cap.
    1.