FRANCHISED FORD GUMBALL MACHINE WATER SLIDE DECAL ORIGINAL NOS

Description

Your bid is for (1)
Original
FORD GUMBALL MACHINE decal, as pictured.
This a New Old Stock Water slide Decal, not a cheap reproduction!!!
Dimensions are approximately 2'' by 3''
Pictures don't do justice at times, but there is no problems and decals have vibrant colors, instructions below are a bit much, it's much easier then it's stated below:
JUST TO GET IT RIGHT WITH BUYERS...THESE DECALS OR ANY OTHER DECALS SOLD BY ME ARE ORIGINALS, NOT SOMETHING PRINTED OFF A PRINTER....
ALL ORIGINALS WITH AGING ON THE PAPER ONLY AND BAD PICTURES OR NOT THE  DECALS ARE IN EXCELLENT CONDITION WITH VIBRANT COLORS AND NO ISSUES OF CRACKING OR SEPARATION THAT COMES WITH AGE.
I have more, decals listed, or not.
These are a use it once, it's yours, no returns! Take your time when using water decals..
REQUIRED TOOLS
• Small Sharp Scissors or X-Acto Knife
• Spray Bottle or Bowl of Clean Room Temperature Water (distilled water is preferred)
• Paper Towel
• Small Soft Brush
OPTIONAL TOOLS
• One of the following clear coat sprays; Testors Glosscote* or Testors Dullcote* (many other clear coat sprays will work as well)
• Microscale Liquid Decal Film*
• Microscale Micro Set*
• Microscale Micro Sol* or Walthers Solvaset*
*these products can typically be purchased from your local hobby store or online.
WARNING!
Waterslide decals are extremely delicate and require care. If not applied properly the decal may scratch, rip or tear during application.  It is suggested that you do testing before you apply your purchased product.
APPLICATION
Application surface should be as smooth as possible.  Make sure you have cleaned the application surface, insuring that it is free of any oils and debris.  If you plan to clear coat the decal, it is recommended that you first apply a clear coat over the application surface and allow coating to dry.  This will insure that the application surface is smooth and any previous pores are sealed.
If you would like to thicken the decal film before applying you may use Microscale Liquid Decal Film to do so. You can apply using a soft brush; let dry for 20 minutes.  It is also beneficial to apply liquid decal film if you decals have been sitting for more than 2 years after receiving.  Liquid decal film will also protect the printed ink from scratches and some chemical reactions from clear coats.  Liquid decal film is not required or recommended if you are applying fresh decals and want best end results.
Remove decal sheet from packaging gently. Cut out decal in square/rectangular/c